Found on Govdeals.com:
2000 Pierce Dash Tower
Auction Ends: 8/25/21 at 1:20 PM ET
Time Remaining: 16 Days 1 Hour
This item is subject to an auto extension of the auction end time.
This item is also subject to Seller Approval.
Buyer’s Premium: 12.50%
Starting Bid: $1.00
Total Bids: 17
High Bidder: s*********5
Current Bid: $4,000.00
Bid Increment: $50.00
Minimum Bid: $4,050.00
2000 PIERCE DASH 4P1CT02S0YA000302 33,238 No Title Restriction 2000 Pierce Dash Tower; VIN# 4P1CT02SOYA000302; 2000 Dash Aerial Platform; Aluminum Body; 100’ Ladder; 1500 GPM Waterous Pump; Engine: Detroit 60 Series 500 HP; Transmission: Allison HD-4060PR; Miles: 33,238; Aerial: 1,541; Engine Hours: 5,364; Pump Hours: 167; Generator Hours: 129; Front Axle: 21,500 lbs; Rear Axle: 58,000 lbs; Taken out of service due to corrosion and a hole in the Torque Box near the frame rail; New 15KW Hydraulic Generator replaced on 4/14/15; New Hot Shift PTO Assembly; Ladder Extension Cylinders rebuilt 3/15/18; Runs Good; Sold As-Is.
Carpentersville FD photo
Carpentersville FD photo
Thanks Martin
This 2000 Pierce Dash Tower is currently up for bid on Govdeals.com with a current bid of $4,000. The auction is set to end on August 25th at 1:20 PM ET, but it may be extended if there are last-minute bids. With a buyer's premium of 12.5%, this could quickly add up. The minimum bid is now $4,050, so bidders should be prepared. This unit has been well-maintained over the years, though it was taken out of service due to some corrosion and damage to the torque box. It still runs good and is being sold as-is. If you're looking for a reliable aerial platform, this might be a great opportunity. Don't miss your chance to grab this equipment before the auction ends!
Needle bar is an important component of a Warp Knitting Machine. It is a long, thin metal bar that holds the needles used to form the knitted fabric. The needle bar is mounted on the machine and moves up and down, allowing the needles to pass through the yarn and create the stitches.
The needle bar typically has a series of holes drilled into it, with each hole holding a single needle. The needles are usually made of steel and have a hooked end that catches the yarn and pulls it through the fabric. The number of needles on the bar can vary depending on the machine and the type of fabric being produced.
In warp knitting machines, the needle bar is typically located above the warp yarns, which are held under tension by a series of guides and rollers. As the needle bar moves up and down, the needles pass through the warp yarns, creating loops that are held in place by the tension of the yarns.
The needle bar is a critical component of the warp knitting machine, and must be carefully maintained to ensure that the needles are properly aligned and functioning correctly. Regular cleaning and lubrication are essential to prevent wear and tear on the needles and the bar itself.
Needle Bar,Stretcher Bars For Punch Needle,Needle Bar Connecting Link,Needle Bar Thread Guide Brother
suzhou cotex international Co.,Ltd , https://www.cotexmill.com