Passenger coaches are the most commonly used means of transportation for people to travel. Whether it is a public transportation bus or a car that bears major transportation during the Spring Festival, passenger cars are the most commonly used buses. However, bus accidents occurred from time to time, causing serious disasters to many families. Perhaps we all saw these accidents in the news report may feel that these are far away from us, but take precautions. The following gives Xiao Bian to everyone to bring passengers in distress to escape graphic teaching.
Rollover of the vehicle
Look for the escape window at the top of the bus, find the position of the exhaust fan at the top of the bus, turn the manual device, and exit the escape window.
The vehicle does not roll over and the door does not open properly
The passenger car door cannot be opened normally. You can try to use the safety door. If the safety door cannot be opened, you can only use the safety hammer and windshield. However, when using the safety hammer, it is important to take care that the safety hammer is used to break the glass.
How to use the safety hammer
1. Pick up the hammer and hammer the four corners of the tempered glass. Do not strike the middle part. The middle part is the strongest.
2. Because some glass is filmed, the glass will not be detached immediately after it is broken. We can open it with our feet.
3. After the glass breaks out, it must jump out of the car body in an orderly manner and move to a safe place. The key is to use the tip of the hammer to strike the four corners, and knocking the middle is not enough.
In the final escape, care should be taken not to greed for finances. Don't waste precious time for your escape because you have valuables in mind. Do not blindly crowd each other and chaos. Follow the guidelines, pay attention to the bright spot, and run against the fresh air.
ER70S-6 Welding Wire
Description: ER70S-6 Welding wire is a low alloy steel gas shielded welding wire, protected with pure Co2 or Ar+CO2 gas. Stable arc, low spatters, excellent fabrication weldability and lowsensitivity of weld gas porosity can be obtained during welding. It is suitable for all position welding especially with large welding current rang. It can show very good welding performance.
Applications:
Suitable for single-pass and multi-pass welding for structures fabricated by carbon steel and 500MPa grade low alloy steel, such as vehicles, bridges, construction and mechanical structures etc.
Instructions:
A. Suitable for using shielding gas at the speed of 20-25 liters per minute.
B. Windshield must be set up in the welding zone, due to gas porosity may be caused be strong wind.
C. Wind extention should be 10-20mm if the current range is under 300A and if above 300A,20-25mm.
Aws E70S-6 Welding Wire,70S-6 Welding Wire,Rutile Welding Rod,2.5Mm Welding Rod
Dingzhou Jinlong Metal Production Co., Ltd. , https://www.weldingelectrodefactory.com